News — Horizontal injection molding machine

Question: Sumitomo S5 decoder abnormality ？ Answer: Sumitomo electric 5# machine SE30D after debugging the origin, power on the s5 decoder abnormality alarm, release steps are shown below.Warming up is completed. I/O check → Preparation mode (cut to change) → Release back after mold thickness (to the end).Mold lock key + Alarm release key + Release key after mold thickness (press simultaneously for 2 seconds to release, the alarm will be released) → Preparation mode (cut with change) → FinishSumitomo i5/m5 alarm:Mold lock + Injection key + Alarm release key (press and release for 10 seconds at the same time,...

Q: Injection molding machine oil temperature from 40 degrees jumped to 01 degrees, the alarm shows that the normal temperature is not reached, replaced the oil temperature sensor will be the same again, the oil temperature line shorting is the same, each this is where the problem? A: 1 Check the temperature sensing wire connection or connection wire connector for shorts. 2 Shorting can't be handled. That means it has nothing to do with the external wiring. It's the temperature board.

The vertical injection molding machine It is used to make two or three different materials injection， The item volume is usually small. while the horrid little injection molding machine is to make the kinds  Big volume plastics，pure plastics mainly.